|Perun Moto rack and extension plate for the KTM 690 Enduro|
At the time I bought my Nomadic rack it was the best and nicest looking* rear rack available. Since then Perun Moto has come out with a better design.
* just my opinion of course
* just my opinion of course
By better I mean
1. More options for attaching straps to the rack. 16 on the Perun model vs. 8 on the Nomadic rack. This is important as the lack of slots was a bit of a problem for me with the Nomadic
2. Visually better design. The Perun version fits the bikes lines very nicely
3. Bumper added to the underside to limit flex and vibration and also reduce stress to the mounting bolts.
The Perun Moto design, while being made of slightly thinner material than the Nomadic, is bent much less aggressively than the Nomadic and the lower support also extends much further to the rear. These combined with the bumper design should at least in theory make the Perun rack a long lasting solution.
The trade-off of the Perun design is the relative narrowness of the rack which can be seen in the photo below. This is not a big problem though, as Perun Moto also sells an extension plate to the rack that when attached gives you more real estate than the Nomadic rack. The extension plate attaches with 4 bolts and can be attached without removing the rack so putting it on and taking it off when needed is not a big deal. That said I'm planning on mostly keeping the extension plate off the bike and attaching only for longer trips when I need the maximum carrying capacity.
I liked the design before, but now that I got my hands on it I like it even more. If you are in the market for a rear rack I highly recommend considering Perun's products. While the product is good, he also communicates swiftly and ships quickly. Maybe most importantly he is the one making and designing the stuff AND he actually owns and rides the bike the products are made for. Oh, and supporting the little guy over Touratwat for example is always commendable.
Where to Buy: Perun Moto
(And no, I get no percentage from the sales.)
|The Perun rack has 16 slots suitable for straps compared to 8 on the Nomadic rack. Both are drilled to accept a rotopax mount|
|Undersides of both racks|
|A key difference on the Perun rack are the rubber pads under the rack|
|The extension plate gets you more attachment options and space|
|Comparison between the Perun rack and the Nomadic rack. Visually the Perun rack fits the 690 Enduro a lot better.|
|The Perun rack is made of slightly thinner material than the Nomadic.|
|Bends on the Perun rack are much gentler than on the Nomadic rack. The larger the radius on a bend the better, from a durability standpoint.|
|The Nomadic rack has quite aggressive bends which in theory are potential weak points / failure points|
|The Perun rack is supported from the back while most others like the Nomadic are not|
I wanted to use the longer spacers that came with the RR side racks for 2 reasons. I felt that the rubber bumpers pressed quite firmly on the rear fender and I wanted a little more clearance between the fender and RR racks. This meant that I needed to get longer (80mm) bolts to replace the ones that came with the Perun rack.
BTW, I measured the holes with the rack and Perun spacers in place and I think the bolts could be a bit longer even if no customization is done. That or I measured incorrectly.
|Perun spacer and RR spacer|
|Longer bolt and the original Perun Moto bolt|
|I also used the form washers that came with the RR rack.|